The Vulnerable Parts Of The Rapid Splitter

Comments · 49 Views

. In the production process of the Rapid Splitter, the size of the material is selected through the screen, and the fan is sent to the outlet

  Chipper Shredder is a crushing mechanical equipment. It has a wide range of applications in many industries. It helps to recycle a large amount of waste wood and effectively eliminates the pollution caused by waste wood in the process. At the same time, these waste wood has high utility value after being crushed by a wood crusher, and can be used for papermaking, power generation, concrete pads, feed, fertilizer, organic mulch, sawdust, slabs, slabs, slabs, slabs, etc. Slabs, aromatherapy mosquitoes, edible fungi, insulation materials, etc. Because the Rapid Splitter is a rotary crusher, it absolutely needs to maintain and maintain a high-strength state for a long time.

  Before maintenance and repair, we need to know the vulnerable parts of Rapid Splitter. These vulnerable parts require us to focus on maintenance and maintenance. The vulnerable parts of Rapid Splitter usually have blades, bearings and screens. Net and so on. One is the blade, because the blade will directly affect the total output and crushing efficiency of the Rapid Splitter, and once abrasion occurs, the output and crushing efficiency of the Rapid Splitter will be reduced. Therefore, after the daily production operation is over, we will inspect the blades of the wood shredder. If it is found to be worn, we can try to use a sharpener to repair the sand. If there is a large gap that cannot be repaired, a new gap needs to be replaced.

   The second is to keep the bearings of the Rapid Splitter. The bearing is the more important transmission component of the Rapid Splitter. Usually, we need to add lubricating oil every 72 hours to reduce the friction and working temperature of the bearing. .

  The screen is an important part of the screening material in the Rapid Splitter. In the production process of the Rapid Splitter, the size of the material is selected through the screen, and the fan is sent to the outlet, some of which have higher water content. During the screening process, raw materials may get stuck in the holes of the screen, which may cause blockage of the screen. Therefore, we need to clean the screen after the daily production operation is over to avoid the screen appearing in the next production process. Network congestion.

Comments